GPRS (General Packet Radio Service) is a method of enhancing 2G phones to enable them to send and receive data more rapidly. With a GPRS connection, the phone is "always on" and can transfer data immediately, and at higher speeds: typically 32 - 48 kbps. An additional benefit is that data can be transferred at the same time as making a voice call. GPRS is now available on most new phones.
GPRS is part of a series of technologies that are designed to move 2G networks closer to the performance of 3G networks. The key characteristic of a 3G network is its ability to transfer large amounts of data at high speed (up to 2 Mbps), enabling applications like video calling, video downloads, web browsing, email, etc. By increasing the speed of a 2G network, some of these applications become possible, e.g. web browsing and sending or receiving emails with large attachments. These technologies are called 2.5G and include enhancements to the CSD technology, such as HSCSD and EDGE.
GPRS Class Types:
The class of a GPRS phone determines the speed at which data can be transferred. Technically the class refers to the number of timeslots available for upload (sending data from the phone) or download (receiving data from the network). The timeslots used for data are in addition to the slot that is reserved for voice calls. These timeslots are available simultaneously, so the greater the number of slots, the faster the data transfer speed. Because GPRS transmits data in packets, the timeslots are not in use all the time, but are shared amongst all users of the network. That increases the overall data capacity of the network, and it also means that you are billed for the quantity of data transmitted, not the time that you are online. It may mean that during busy times, data transfer rates slow down, because the network will give priority to voice calls.
GPRS (General Packet Radio Service)
EDGE( Enhanced Data Rates for GSM Evolution)
Enhanced Data rates for GSM Evolution (EDGE) (also known as Enhanced GPRS (EGPRS), or IMT Single Carrier (IMT-SC)) is a backward-compatible digital mobile phone technology that allows improved data transmission rates, as an extension on top of standard GSM. EDGE is considered a 3G radio technology and is part of ITU's 3G definition.EDGE was deployed on GSM networks beginning in 2003— initially by Cingular (now AT&T) in the United States.
EDGE is standardized by 3GPP as part of the GSM family, and it is an upgrade that provides more than three-fold increase in both the capacity and performance of GSM/GPRS networks. It does this by introducing sophisticated methods of coding and transmitting data, delivering higher bit-rates per radio channel.
EDGE can be used for any packet switched application, such as an Internet connection. EDGE-delivered data services create a broadband internet-like experience for the mobile phone user. High-speed data applications such as video services and other multimedia benefit from EGPRS' increased data capacity.
Evolved EDGE continues in Release 7 of the 3GPP standard providing reduced latency and more than doubled performance e.g. to complement High-Speed Packet Access (HSPA). Peak bit-rates of up to 1Mbit/s and typical bit-rates of 400kbit/s can be expected.
Technology:
EDGE/EGPRS is implemented as a bolt-on enhancement for 2G and 2.5G GSM and GPRS networks, making it easier for existing GSM carriers to upgrade to it. EDGE/EGPRS is a superset to GPRS and can function on any network with GPRS deployed on it, provided the carrier implements the necessary upgrade.
EDGE requires no hardware or software changes to be made in GSM core networks. EDGE compatible transceiver units must be installed and the base station subsystem needs to be upgraded to support EDGE. If the operator already has this in place, which is often the case today, the network can be upgraded to EDGE by activating an optional software feature. Today EDGE is supported by all major chip vendors for both GSM and WCDMA/HSPA.
Transmission techniques :
In addition to Gaussian minimum-shift keying (GMSK), EDGE uses higher-order PSK/8 phase shift keying (8PSK) for the upper five of its nine modulation and coding schemes. EDGE produces a 3-bit word for every change in carrier phase. This effectively triples the gross data rate offered by GSM. EDGE, like GPRS, uses a rate adaptation algorithm that adapts the modulation and coding scheme (MCS) according to the quality of the radio channel, and thus the bit rate and robustness of data transmission. It introduces a new technology not found in GPRS, Incremental Redundancy, which, instead of retransmitting disturbed packets, sends more redundancy information to be combined in the receiver. This increases the probability of correct decoding.
EDGE can carry data speeds up to 236.8 kbit/s (with end-to-end latency of less than 150 ms) for 4 timeslots (theoretical maximum is 473.6 kbit/s for 8 timeslots) in packet mode. This means it can handle four times as much traffic as standard GPRS. EDGE meets the International Telecommunications Union's requirement for a 3G network, and has been accepted by the ITU as part of the IMT-2000 family of 3G standards. It also enhances the circuit data mode called HSCSD, increasing the data rate of this service. EDGE is part of ITU's 3G definition and is considered a 3G radio technology.
EDGE Evolution:
EDGE Evolution improves on EDGE in a number of ways. Latencies are reduced by lowering the Transmission Time Interval by half (from 20 ms to 10 ms). Bit rates are increased up to 1 MBit/s peak speed and latencies down to 800 ms using dual carriers, higher symbol rate and higher-order modulation (32QAM and 16QAM instead of 8-PSK), and turbo codes to improve error correction. And finally signal quality is improved using dual antennas improving average bit-rates and spectrum efficiency. EDGE Evolution can be gradually introduced as software upgrades, taking advantage of the installed base. With EDGE Evolution, end-users will be able to experience mobile internet connections corresponding to a 500 kbit/s ADSL service.
MIMO and OFDM
MIMO is applicable to all kinds of wireless communication technologies. However, the combination of MIMO and OFDM (Orthogonal Frequency Division Multiplex) has the following advantages. OFDM is adapted for multi-path propagation in wireless systems. The length of the OFDM-frames is determined by the Guard Interval (GI). This Gurad Interval restricts the maximum path delay and therefore the expansion of the network area. MIMO also uses the multi-path propagation.
OFDM is a wideband system with many narrowband sub-carriers. The mathematical MIMO channel model is based on a narrow band non-frequency selective channel. The latter is supported by OFDM as well. Fading effects in wideband systems normally occur only at particular frequencies and interfere with few sub-carriers. The data is spread over all carriers, so that only a small amount of bits get lost, and these can be
repaired by a forward error correction (FEC). OFDM provides a robust multi-path system suitable for MIMO. At the same time OFDM provides high spectral efficiency and a degree of freedom in spreading the time dimension of Space-Time Block Codes over several sub-carriers. This results in a stronger system based on the principle described previously
MIMO Standards:
Table 1 gives an overview of all current MIMO standards and their technologies. It is clear to see, that with the exception of 3GPP Release 7, all standards work with OFDM. The advantages of OFDM can obviously be linked to MIMO.
Table 1 MIMO Standards and the corresponding technology :
Standard Technology
WLAN 802.11n OFDM
WiMAX 802.16-2004 OFDM/OFDMA
WiMAX 802.16e OFDMA
3GPP Release 7 WCDMA
3GPP Release 8 (LTE) OFDMA
802.20 OFDM
802.22 OFDM
